הכן את הרדיו של המקלט פשוט
Using a serial terminal program and AT commands (or X-CTU if you have access), configure the XBee Series 1 radio with the settings below:
|PAN ID||ATID||3001 (any address from 0 to FFFE will do)|
|MY Address||ATMY||0 (any address from 0 to FFFE will do)|
|Destination Low||ATDL||0 (this is only a receiver, destination optional)|
|Digital I/O pin 0||ATD0||4 (digital output, low to begin with)|
|Input sample rate||ATIR||FFFF (accept I/O commands from any radio)|
When you’re finished, check your work by reissuing each AT command without any parameter so the radio can show you the addresses and register settings that it’s using. As a final step, use the ATWR command to write the new configuration to your radio’s firmware so it’s saved for the next power-up.